ProSeriesRacing
Plastic
- Joined
- Aug 9, 2018
Picked up this lathe a few weeks ago and pulled the chuck off to find this spindle reducer I hope!
I have beaten on this reducer a few times and see no movement. Used a 3ft long 1 3/4 od rod and 5lb hammer. Very hard to see if this is even pressed in the spindle, the piece is 4" long with 1.125 ID
Do I need to disassemble this area more to find hidden bolts or set screws? Apply heat and pound on it some more?
I have beaten on this reducer a few times and see no movement. Used a 3ft long 1 3/4 od rod and 5lb hammer. Very hard to see if this is even pressed in the spindle, the piece is 4" long with 1.125 ID
Do I need to disassemble this area more to find hidden bolts or set screws? Apply heat and pound on it some more?