killerbeege
Plastic
- Joined
- Dec 12, 2020
Good morning,
I am IT by trade and know absolutely nothing about CNC machines. I am helping a neighbor that runs a small machine shop in his garage with his mazak qt10. He wants to pull the program off the machine? He does have the DB25 to RJ12 cable that came with the machine.
I use to program cash registers with com ports so I am knowledgeable about building the cables and baud rates.
I was looking at this to build it to a DB9 and use a DB9 to USB adapter
https://www.amazon.com/Keen-Eye-Mod...11+to+db9&qid=1607786308&s=electronics&sr=1-8
I have searched all over and can not find any information on this machine's pin out. I have found every other machine though!
How do I connect this to the computer?
What program am I using?
What is the baud rate information?
Thank you for any help!
I am IT by trade and know absolutely nothing about CNC machines. I am helping a neighbor that runs a small machine shop in his garage with his mazak qt10. He wants to pull the program off the machine? He does have the DB25 to RJ12 cable that came with the machine.
I use to program cash registers with com ports so I am knowledgeable about building the cables and baud rates.
I was looking at this to build it to a DB9 and use a DB9 to USB adapter
https://www.amazon.com/Keen-Eye-Mod...11+to+db9&qid=1607786308&s=electronics&sr=1-8
I have searched all over and can not find any information on this machine's pin out. I have found every other machine though!
How do I connect this to the computer?
What program am I using?
What is the baud rate information?
Thank you for any help!