Hello!
On my QT20N with T2 control, during a drilling operation with a 35 mm drill, machine went to NMI Emergency Stop.
I think that Z driver was overloaded.
From that moment on machine doesn't work anymore.
After PowerOn i get same 20 NMI Emergency Stop and on the FX61 board i have MCUAL led ON. Also on control panel NC Alarm is also ON.
On diagnose page on MCU Version I get a strange %2 :A and i dont know if this is beacause of servo drive fail or a FX61 board fail.
May be Z axis overload related to the error shown on screen? I realy need some advices.
On my QT20N with T2 control, during a drilling operation with a 35 mm drill, machine went to NMI Emergency Stop.
I think that Z driver was overloaded.
From that moment on machine doesn't work anymore.
After PowerOn i get same 20 NMI Emergency Stop and on the FX61 board i have MCUAL led ON. Also on control panel NC Alarm is also ON.
On diagnose page on MCU Version I get a strange %2 :A and i dont know if this is beacause of servo drive fail or a FX61 board fail.
May be Z axis overload related to the error shown on screen? I realy need some advices.