What's new
What's new

QT15 T-2 Parameter help

blgmachine

Cast Iron
Joined
Feb 16, 2010
Location
Wisconsin
if someone with this control could look up a few parameters it would help

Machine Parameter page 1

BL FOR X & Y
ZP FOR X & Y
B5
B6

Thanks for the help
 
if someone with this control could look up a few parameters it would help

Machine Parameter page 1

BL FOR X & Y
ZP FOR X & Y
B5
B6

Thanks for the help

You canot simply take these parameters from another machine.
BL = BackLash, you have to measure this on your machine and adjust it until you have no backlash.
I dont remember the other ones in my head.
 
how do you measure this backlash
will this give me a z axis alarm

No it will not give you any alarm if BL is wrong.
Put an indicator between a static place and the turret then use the wheel to move X or Z.
When you change direction it should not be any delay or jump on the indicator.
If the indicator jumps you decrease BL but if there is a delay you increase BL.

Newbie tips: if you press both X1 and X10 handwheel buttons you will get X100
 
I was able to home machine and use handle jog.
Machine sat fine for 15 minutes then some disturbing noise came from drive and
alarms 14 and 20 started to flash.Drive is on its way to precision zone along with motor
 








 
Back
Top