benganboll
Hot Rolled
- Joined
- Feb 23, 2015
- Location
- Sweden Östersund
I dont know how to describe this problem that only seems to happen when the machine is warm (like 10 hours of work)
It will change a little bit in X axis and if I dont notice it it will change more.
All tools on that turret is affected and a reboot will reset it to normal.
In this film I have notice it when is "only" moved 0,075mm but I have seen 0,3mm aswell.
Before reboot X is at 0, after reboot X is at -0,075 but the turret have not moved.
(No there is no backlash at this axle)
Strange Mazatrol T32-6 problem - YouTube
It will change a little bit in X axis and if I dont notice it it will change more.
All tools on that turret is affected and a reboot will reset it to normal.
In this film I have notice it when is "only" moved 0,075mm but I have seen 0,3mm aswell.
Before reboot X is at 0, after reboot X is at -0,075 but the turret have not moved.
(No there is no backlash at this axle)
Strange Mazatrol T32-6 problem - YouTube