Hey guys, I’m super new here. Just joined today. I recently purchased a Mazak QT15 with T-2 control. It had been sitting for awhile so I knew I needed to do the re-Intialization. Well I tried it several times and no matter what it still will not let me input the parameters. There are asterisks on P column. I’m stuck and don’t know what to do. Any help is appreciated. Thank you!
Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
Largest Manufacturing Technology Community on the Web
Stay Connected:
Parameter Help
- Thread starter Spoolbus
- Start date
- Replies 1
- Views 1,144
ifixcnc
Hot Rolled
- Joined
- Feb 6, 2015
- Location
- Cleveland Ohio
Our T2 is funny when the battery's are low.
Sometimes just leaving it on for several hours will build up enough charge that it will load.
There are multiple battery's.
Sometimes just leaving it on for several hours will build up enough charge that it will load.
There are multiple battery's.
