benganboll
Hot Rolled
- Joined
- Feb 23, 2015
- Location
- Sweden Östersund
I am going to put in new ball screws in both Z axis on a Multiplex 6200Y with fusion 640T.
My ide is to take the current Z offset of tool 1 and after changing ball screw change the parameters to come as close to the same numbers as possible.
Will that give all programs the correct Z offsets?
What paramer should I change?
My ide is to take the current Z offset of tool 1 and after changing ball screw change the parameters to come as close to the same numbers as possible.
Will that give all programs the correct Z offsets?
What paramer should I change?