Captdave
Titanium
- Joined
- Sep 24, 2006
- Location
- Atlanta, GA
Haven't fired up the QT-8 in several months and of course the backup battery was dead. This machine has had a 10 year history of draining the battery if off too long but that's a different matter all together and has nothing to do with the current issue.
Have a good hard copy of the parameters (been down this road before) so reloading them has never been an issue. Was working on Machine parameter page 11 on either R60 or R61 when the alarm showed up. At this point, the screen is still on but none of the soft keys will allow a page change or a way to get back to the parameter pages.
The complete alarm is: WN buss error 0 PO error at or near $005B0e5C showing up in the upper left hand corner of the screen.
The Parameter book says machine parameter pages 5-11 omitted. IIRC R49-R80 are bit changes to turn on and off special functions such as R49 bit 2 turns on M codes in auto mode so you can ope/close the chuck for bar feeding, the rest of them I have no clue and suspect that R60 or R61 is what has caused the alarm.
Have a good hard copy of the parameters (been down this road before) so reloading them has never been an issue. Was working on Machine parameter page 11 on either R60 or R61 when the alarm showed up. At this point, the screen is still on but none of the soft keys will allow a page change or a way to get back to the parameter pages.
The complete alarm is: WN buss error 0 PO error at or near $005B0e5C showing up in the upper left hand corner of the screen.
The Parameter book says machine parameter pages 5-11 omitted. IIRC R49-R80 are bit changes to turn on and off special functions such as R49 bit 2 turns on M codes in auto mode so you can ope/close the chuck for bar feeding, the rest of them I have no clue and suspect that R60 or R61 is what has caused the alarm.