cwtoyota
Cast Iron
- Joined
- Feb 11, 2010
- Location
- Washington State
QT-10, T2-CAM, Troubleshooting X & Z axis drive not ready (Solved!)
I started this post, realized I had written a novel, so I made the short version and I'll reply below with more detail.
I'm looking for troubleshooting information for the TR8A-L servo drive, TR43B top-board and the FX-61 board.
Specifically I need to know what signals the servo drive and top-board must receive from the control for the servo drive to start up and run.
I started this post, realized I had written a novel, so I made the short version and I'll reply below with more detail.
I'm looking for troubleshooting information for the TR8A-L servo drive, TR43B top-board and the FX-61 board.
Specifically I need to know what signals the servo drive and top-board must receive from the control for the servo drive to start up and run.
Last edited: