ManualEd
Stainless
- Joined
- Oct 13, 2014
- Location
- Kelowna, Canada
Finally got everything I need to transfer programs out of my SQT15MS.
I tried connecting a PC to the control with Mazview, but in the setting I'm not having anything show up under "Communications Port".
There are two 25pin connectors under the control, and I've tried both of them. Just using a standard RS232 25 pin to USB cable.
Anything else I should be doing?
Attached are some relevant photos. The website photo claims those are the settings needed for DNC (what does that stand for?)
Thanks for any help.
I tried connecting a PC to the control with Mazview, but in the setting I'm not having anything show up under "Communications Port".
There are two 25pin connectors under the control, and I've tried both of them. Just using a standard RS232 25 pin to USB cable.
Anything else I should be doing?
Attached are some relevant photos. The website photo claims those are the settings needed for DNC (what does that stand for?)
Thanks for any help.