JohnXKennedy
Plastic
- Joined
- Jun 6, 2017
Hey guys,
I finally have my QT10 connected to 240 3ph and can connect the main breaker however -
-The control does not seem to 'boot', I only get static on the CRT if I press the "power on" button on the operating panel.
-The hydraulic pump does not turn on, presumably because the NC is not actually on, so to check phasing I have heard there is a light on the spindle VFD - Which light should I be looking for? There are no warning codes on the VFD display...
I have the parameters for the machine I believe, so if I can get it to power up properly I have hope I can get it working properly.
Thank you!
I finally have my QT10 connected to 240 3ph and can connect the main breaker however -
-The control does not seem to 'boot', I only get static on the CRT if I press the "power on" button on the operating panel.
-The hydraulic pump does not turn on, presumably because the NC is not actually on, so to check phasing I have heard there is a light on the spindle VFD - Which light should I be looking for? There are no warning codes on the VFD display...
I have the parameters for the machine I believe, so if I can get it to power up properly I have hope I can get it working properly.
Thank you!