benganboll
Hot Rolled
- Joined
- Feb 23, 2015
- Location
- Sweden Östersund
I have a Multiplex 620 since a few mounths ago and I notice that bar out is waiting for correct spindlespeed 1mm into the workpiece.
That is a problem for my insersts
Mazatrol T32-6 behaving strange - YouTube
Checked TPC and no change if I add more clearance at Z
Same problem on both sides and on all programs.
That is a problem for my insersts
Mazatrol T32-6 behaving strange - YouTube
Checked TPC and no change if I add more clearance at Z
Same problem on both sides and on all programs.
