xa-mont
Hot Rolled
- Joined
- Apr 4, 2014
- Location
- Victoria, Australia
Hey guys,
I'm having issues with one of the servo amps on my VQC20-40a (M2)
It will intermittently not work on startup. the fault condition can be seen in the photo below, but basically i've traced the fault to the TR23D-31-A board (i swapped the whole TRA31A from x and y axis and the fault followed the board, then i swapped the TR23D-31-A and the fault again followed that, so it must be at fault.
Has anyone repaired one before? is there something that is common to go on them?
I should hopefully have a spare on the way (second hand also) but would like to be able to fix this one if i can.
Cheers,
Trav
I'm having issues with one of the servo amps on my VQC20-40a (M2)
It will intermittently not work on startup. the fault condition can be seen in the photo below, but basically i've traced the fault to the TR23D-31-A board (i swapped the whole TRA31A from x and y axis and the fault followed the board, then i swapped the TR23D-31-A and the fault again followed that, so it must be at fault.
Has anyone repaired one before? is there something that is common to go on them?
I should hopefully have a spare on the way (second hand also) but would like to be able to fix this one if i can.
Cheers,
Trav