Hello all,
I'm trying to use the tool eye for broken tool detection and don't know how to go about it. All I know is G36 is used but that's all. Is checking for a broken tool with the tool eye possible? All I need is Z tool length, not X. I'm using 1mm EM in titanium and want to check it in auto mode. If anyone has some NC I can review I could sure use it.
Machine is 2001 Integrex 200IISY with 640MT controller.
Thanks in advance!
Brad
I'm trying to use the tool eye for broken tool detection and don't know how to go about it. All I know is G36 is used but that's all. Is checking for a broken tool with the tool eye possible? All I need is Z tool length, not X. I'm using 1mm EM in titanium and want to check it in auto mode. If anyone has some NC I can review I could sure use it.
Machine is 2001 Integrex 200IISY with 640MT controller.
Thanks in advance!
Brad