I picked up a Brown and sharpe Microval that has micromeasure 3.
It was working but apparently I did something to make it error out on startup
DOS is still working fine. It’s just the micromeasure program giving a runtime error of r6003
Thanks
Tim
Got it working again.
What I had changed was in the mm3 setup program
I had switched the display from ega to vga and saved that to drive c
Switching back and saving again to c fixed it
Tim
This website or its third-party tools process personal data (e.g. browsing data or IP addresses) and use cookies or other identifiers, which are necessary for its functioning and required to achieve the purposes illustrated in the cookie policy. To learn more, please refer to the cookie policy. In case of sale of your personal information, you may opt out by sending us an email via our Contact Us page. To find out more about the categories of personal information collected and the purposes for which such information will be used, please refer to our privacy policy. You accept the use of cookies or other identifiers by closing or dismissing this notice, by scrolling this page, by clicking a link or button or by continuing to browse otherwise.