I am looking for suggestions on who to contact to make a custom air gauge?
Our part is 250mm long thin walled stainless tube (open ended). The target ID is just over 17mm and we are trying to measure within +/- 0.015mm Inside surface is honed. Currently measured using a 3 point ID mic which takes a long time per part. We measure 3 points (close to ends and around middle).
I'm thinking of an air gauge with three points of measurement that can measure this in one go with even a dummy operator. Total 6 measurements so that the part is rotated 90 degrees between. We have no experience with air gauges at all. Any suggestions who to contact for something like this? Doesn't really matter where in the world, we have an office in USA and Europe, the measurements are done in Taiwan.
Our part is 250mm long thin walled stainless tube (open ended). The target ID is just over 17mm and we are trying to measure within +/- 0.015mm Inside surface is honed. Currently measured using a 3 point ID mic which takes a long time per part. We measure 3 points (close to ends and around middle).
I'm thinking of an air gauge with three points of measurement that can measure this in one go with even a dummy operator. Total 6 measurements so that the part is rotated 90 degrees between. We have no experience with air gauges at all. Any suggestions who to contact for something like this? Doesn't really matter where in the world, we have an office in USA and Europe, the measurements are done in Taiwan.