I'm trying to understand how difficult it is to 'laser measure' something. I believe it's most commonly done using a Faro Arm, but could be wrong.
In any case....in the sketch below, A and B represent the machined feet of a fabricated steel structure. I want to verify they have been machined properly....the spec requires they be on the same horizontal plane within .005".
Assuming this structure is sitting indoors in a shop (in Minneapolis, MN) and the feet are accessible, is this a 'big' job? Who does this sort of work? etc.
Thanks!
In any case....in the sketch below, A and B represent the machined feet of a fabricated steel structure. I want to verify they have been machined properly....the spec requires they be on the same horizontal plane within .005".
Assuming this structure is sitting indoors in a shop (in Minneapolis, MN) and the feet are accessible, is this a 'big' job? Who does this sort of work? etc.
Thanks!