KristianSilva
Aluminum
- Joined
- Nov 26, 2016
Hi,
We are having some debate about how to align this part for inspection, could you please tell me the correct way to align this part on a faro arm/CMM to measure the the hole true positions.
At the moment I am:
1. setting part down on granite table on red face.
2.Measuring datum plane A
3.Measuring datum dia B
4. measuring all holes
5. set up coordinate system with plane A to set Z direction and a line between datum datum dia B and a the csk hole that is at 12 oclock, then datum B dia as the origin.
Then once the co-ord system is setup I just measure true positions to A and B.
Is this correct way to measure true position of these holes? If not, what is the correct way?
Thanks
We are having some debate about how to align this part for inspection, could you please tell me the correct way to align this part on a faro arm/CMM to measure the the hole true positions.
At the moment I am:
1. setting part down on granite table on red face.
2.Measuring datum plane A
3.Measuring datum dia B
4. measuring all holes
5. set up coordinate system with plane A to set Z direction and a line between datum datum dia B and a the csk hole that is at 12 oclock, then datum B dia as the origin.
Then once the co-ord system is setup I just measure true positions to A and B.
Is this correct way to measure true position of these holes? If not, what is the correct way?
Thanks