1953chevB
Cast Iron
- Joined
- Jul 31, 2020
So over the years, 40-50 years the requirements changed and buz words came an gone.
what specification is your quality manual based on and as the title specifies calibration frequency.
My last company was ISO 9001 C certified and when I retire where in Progress of Rev D
which to my under standing was more complicated and stringent.
Now quality engineering was not my function but I would pick up knowledge from the pro's
who would get us ready for the Agency to certify the company. I am forgetting a lot because
I have been out of the loop for several years.
what was the equipment calibration frequency ?
normal equipment was granite surface plates, CMM, Gage Blocks, Height Gages, Dial Indicators, Micrometers and so on
there was two special equipment (gear shop) , (2) CNC Gear Checker, Red Liners ( Rolling with Master Gears)
what specification is your quality manual based on and as the title specifies calibration frequency.
My last company was ISO 9001 C certified and when I retire where in Progress of Rev D
which to my under standing was more complicated and stringent.
Now quality engineering was not my function but I would pick up knowledge from the pro's
who would get us ready for the Agency to certify the company. I am forgetting a lot because
I have been out of the loop for several years.
what was the equipment calibration frequency ?
normal equipment was granite surface plates, CMM, Gage Blocks, Height Gages, Dial Indicators, Micrometers and so on
there was two special equipment (gear shop) , (2) CNC Gear Checker, Red Liners ( Rolling with Master Gears)