Hello All,
I have a 1953 square dial MG 10EE. It has the typical D1-3 mount. There is no collet closer installed on the lathe. My question, is the ID of the nose tapered? From what I can tell it looks pretty straight. If there is a taper, what type is it? If not, what are you using for a center?
I have a 1953 square dial MG 10EE. It has the typical D1-3 mount. There is no collet closer installed on the lathe. My question, is the ID of the nose tapered? From what I can tell it looks pretty straight. If there is a taper, what type is it? If not, what are you using for a center?