I've been working on the taper adapter that came with my 1942 10EE.
In this photo, you'll see a groove cut into the two bar rails that the shoe stud bushing rides against. I don't find any reason for this groove. Nothing I have fits in it.
On this forum, after searching through the 37 pages returned from a search on "taper adapter", I found a photo of the TA with the bars reversed, so the groove is on the outside. But there was subsequent discussion that perhaps THAT photo was wrong.
Is there some kind of cover that is suppose to snap into these grooves?
In this photo, you'll see a groove cut into the two bar rails that the shoe stud bushing rides against. I don't find any reason for this groove. Nothing I have fits in it.
On this forum, after searching through the 37 pages returned from a search on "taper adapter", I found a photo of the TA with the bars reversed, so the groove is on the outside. But there was subsequent discussion that perhaps THAT photo was wrong.
Is there some kind of cover that is suppose to snap into these grooves?