Hi,
I just bought this lathe on an auction. When it was delivered I found that the original power components were replaced with (it looks like to me) an updated power supply. There is no tubes rack, anything in the cabinet. Please see attached pictures.
It looks like someone fork-lifted the lathe and bent the lower control rod. I was wondering if it is as simple as replacing it with a piece of barstock or there will be machining needed to replace it.
She's pretty rough but for $100 plus shipping, I didn't think I did too bad.
Thanks for any comments,
Dan
I just bought this lathe on an auction. When it was delivered I found that the original power components were replaced with (it looks like to me) an updated power supply. There is no tubes rack, anything in the cabinet. Please see attached pictures.
It looks like someone fork-lifted the lathe and bent the lower control rod. I was wondering if it is as simple as replacing it with a piece of barstock or there will be machining needed to replace it.
She's pretty rough but for $100 plus shipping, I didn't think I did too bad.
Thanks for any comments,
Dan