Karl_T
Cast Iron
- Joined
- Jun 13, 2008
- Location
- Dassel,MN,USA
I am looking to buy a second 10EE...
Mine has D1-3 spindle nose. Is this a typo below? Or did they make a Monarch with D1-4?
Karl
Equipped With:
Taper Attachment, Cushman 6" 3-Jaw Chuck, 8-1/4" 3-Jaw Chuck, Collet Closing Nose & Draw Tube,
Description:
Tool Post, Pneumatic Collet Closer and Installed Chuck NOT Included
Electrics:
3-Phase
Manufacturer: Monarch Model: 10 EE Tool Room Lathe Year: 1950 Serial Number: 33144
Main Unit Approx Weight: 3450.00 lbs
Main Unit Dimensions (in inches): Length: 70.00" Width: 32.00" Height: 56.00"
Specs:
Max Sing Over Bed: 12.5
Max Center Distance: 20"
Spindle Speeds: Variable Speed to 2,500 RPM
Max Swing Over Cross-Slide: 7"
Bar Capacity: 1-1/16"
Spindle Nose: D1-4 Camlock
Tailsock Quill Taper: #2MT
Mine has D1-3 spindle nose. Is this a typo below? Or did they make a Monarch with D1-4?
Karl
Equipped With:
Taper Attachment, Cushman 6" 3-Jaw Chuck, 8-1/4" 3-Jaw Chuck, Collet Closing Nose & Draw Tube,
Description:
Tool Post, Pneumatic Collet Closer and Installed Chuck NOT Included
Electrics:
3-Phase
Manufacturer: Monarch Model: 10 EE Tool Room Lathe Year: 1950 Serial Number: 33144
Main Unit Approx Weight: 3450.00 lbs
Main Unit Dimensions (in inches): Length: 70.00" Width: 32.00" Height: 56.00"
Specs:
Max Sing Over Bed: 12.5
Max Center Distance: 20"
Spindle Speeds: Variable Speed to 2,500 RPM
Max Swing Over Cross-Slide: 7"
Bar Capacity: 1-1/16"
Spindle Nose: D1-4 Camlock
Tailsock Quill Taper: #2MT