My EE10's tach is missing the needle and glass and the dial is totally ruined. I'm going to rebuild it. Can someone please take a high-ish resolution photo of a correct dial? You can contact me via the email option or private message option on this website and we can arrange to send to me offline via email.
Speaking of the tach...Cal had a thread about the difficulties of reinstalling the two nuts that hold the tach on the headstock. Apparently, whoever had my lathe had a similar problem. While draining and cleaning the headstock, I found no less than six of those nuts in the bottom, along with three lock washers and the setscrew that had fallen out of one of the reverse gears.
I also spend at least a half hour with a magnet, dragging it around the bottom, picking up metal grit and slag, until it eventually came up clean.
Speaking of the tach...Cal had a thread about the difficulties of reinstalling the two nuts that hold the tach on the headstock. Apparently, whoever had my lathe had a similar problem. While draining and cleaning the headstock, I found no less than six of those nuts in the bottom, along with three lock washers and the setscrew that had fallen out of one of the reverse gears.
I also spend at least a half hour with a magnet, dragging it around the bottom, picking up metal grit and slag, until it eventually came up clean.
Last edited by a moderator: