rimcanyon
Diamond
- Joined
- Sep 28, 2002
- Location
- Salinas, CA USA
What are the resistances for the WIAD Speed Pot? The schematics I have say 10K front and 15k rear.
I am working on the 59 WIAD machine, and I have added ELSR and VSR, so both the fwd and rev speed pots have been tested. I also have a pair of front speed pots that came from WIAD machines.
What I found is a lack of consistency. The VSR pot was 10K front, 15K rear. The front speed pot that came on the 59 was 20K front, 20K rear. The two spares were 20k Front, 15K rear and 10K Front, 15K rear.
So I am using both of the 10k front, 15K rear pots. I am sure the others work, I had the machine running and did not notice any issues with the 20k/20k pot.
For the potential relay, I am using a P&B KUP14D15-110 with an Idec SR3B-05 Relay socket / P&B 27E893. Rather than install the potential relay in the WIAD area, I installed it inside the bed, so the wire runs to ELSR, the push to test and VSR pot are quite short.
I am working on the 59 WIAD machine, and I have added ELSR and VSR, so both the fwd and rev speed pots have been tested. I also have a pair of front speed pots that came from WIAD machines.
What I found is a lack of consistency. The VSR pot was 10K front, 15K rear. The front speed pot that came on the 59 was 20K front, 20K rear. The two spares were 20k Front, 15K rear and 10K Front, 15K rear.
So I am using both of the 10k front, 15K rear pots. I am sure the others work, I had the machine running and did not notice any issues with the 20k/20k pot.
For the potential relay, I am using a P&B KUP14D15-110 with an Idec SR3B-05 Relay socket / P&B 27E893. Rather than install the potential relay in the WIAD area, I installed it inside the bed, so the wire runs to ELSR, the push to test and VSR pot are quite short.
