NeoTech
Plastic
- Joined
- Dec 12, 2011
- Location
- Sweden, Frövi
So i bought these old Okuma LB-15 with OSP5000M-G operating system on them.
They been run with a DNC unit from a central server for a while. But the last owner just never bothered of hooking them up.
Which make me assume that they most likely have a drip feed option..
Anyone knows what steps i should make to figure out the capabilities of the main unit?
I have no manuals or instructions.. i have been clicking around in the machines so far blindly.
Will attach an image of the DNC unit that was connected to the machine
I have never seen such a unit and are not sure if i can use it. But used simpler dnc units on other older siemens machines and would be neat if i could make the dripfeed work.
They been run with a DNC unit from a central server for a while. But the last owner just never bothered of hooking them up.
Which make me assume that they most likely have a drip feed option..
Anyone knows what steps i should make to figure out the capabilities of the main unit?
I have no manuals or instructions.. i have been clicking around in the machines so far blindly.
Will attach an image of the DNC unit that was connected to the machine
I have never seen such a unit and are not sure if i can use it. But used simpler dnc units on other older siemens machines and would be neat if i could make the dripfeed work.