Captdave
Titanium
- Joined
- Sep 24, 2006
- Location
- Atlanta, GA
Not sure that was the most discriptive title so let me explain. When we first start up the control in the morning after it goes through the normal start up of loading the Okuma software for some reason the Renishaw part probe app starts up a few minutes later. If you happen to touch any button/key the app hides behind the Okuma screen.
Later when you need to use the app by touching the soft key it says it's already running. The only way to get it back to the top screen is to power off the control and restart. I've just gone through the operation manual again tonight and it doesn't mention anything about this.
Im sure this was mentioned during training but I don't recall it.
Later when you need to use the app by touching the soft key it says it's already running. The only way to get it back to the top screen is to power off the control and restart. I've just gone through the operation manual again tonight and it doesn't mention anything about this.
Im sure this was mentioned during training but I don't recall it.