Captdave
Titanium
- Joined
- Sep 24, 2006
- Location
- Atlanta, GA
G73 cycle
I'm messing with the post to get the correct format within ONECNC
So here is the code I have currently working,
N2680 (.422 INCH HSS 27/64 DRILL)
N2690 G116 TOOL=28
N2700 T55
N2710 G15 H1
N2720 G0 X-2.175 Y-5.025 M03 S3000
N2730 G00 G56 Z0.5 H28 M08
N2740 G00 X-2.175 Y-5.025 Z0.5
N2750 G73 Z-1.2768 R0.5 Q0.5 F30.0
N2760 X0. Y-1.595
N2770 X2.175 Y-5.025
N2780 G80
N2790 G00 Z0.5
N2800 M09
N2810 M5
N2820 G30 P1
This works fine with two exceptions.
1. This is a through hole at the bottom of a counter bore and I would like it to start feeding at Z-.700, not at the rapid plane. The Q value is set so there is no pecks I guess it doesn't like a zero value.
2. It starts feeding at the rapid plane which isn't needed.
How I have it set up is
rapid plane .5"
Plunge clearance .05"
Material top -.700"
It was set in the post to retract at the initial plane which I didn't catch at first but now its set to retract plane.
I'm messing with the post to get the correct format within ONECNC
So here is the code I have currently working,
N2680 (.422 INCH HSS 27/64 DRILL)
N2690 G116 TOOL=28
N2700 T55
N2710 G15 H1
N2720 G0 X-2.175 Y-5.025 M03 S3000
N2730 G00 G56 Z0.5 H28 M08
N2740 G00 X-2.175 Y-5.025 Z0.5
N2750 G73 Z-1.2768 R0.5 Q0.5 F30.0
N2760 X0. Y-1.595
N2770 X2.175 Y-5.025
N2780 G80
N2790 G00 Z0.5
N2800 M09
N2810 M5
N2820 G30 P1
This works fine with two exceptions.
1. This is a through hole at the bottom of a counter bore and I would like it to start feeding at Z-.700, not at the rapid plane. The Q value is set so there is no pecks I guess it doesn't like a zero value.
2. It starts feeding at the rapid plane which isn't needed.
How I have it set up is
rapid plane .5"
Plunge clearance .05"
Material top -.700"
It was set in the post to retract at the initial plane which I didn't catch at first but now its set to retract plane.