What's new
What's new

MC4VA over travel reset

bigearl67

Hot Rolled
Joined
Apr 10, 2009
Location
Sticks, Indiana
I picked up an Okuma MC4VA in good working condition a month ago with an OSP 5000M-G control. During transport the bed slid forward and now I am getting an over travel fault. I took off the apron and moved the bed manually however the readout on the panel stayed the same. The prox on the bed seems to be working properly and is not engaged now.
My theory is its past the factory over travel resets in the operating system. How do I go in and reset these? Manual doesn’t show this.
 
If this is what I think it is, there is a button in the back panel. Hold that down while someone moves the table off the limits.
It's been a while but I want to say it's a yellow button.
 








 
Back
Top