What's new
What's new

New Genos M560, osp300-ma Missing Tool Wear

tts197

Plastic
Joined
Sep 22, 2018
Any other osp users on the 300-MA control know why I only have a geometry tab and no wear tab? It shows it as an option when you read through the big book but the control on this machine we were under the influence was fully loaded (save for NURBS and NAVI if you didnt get them, we didn't). It doesn't even say geometry in my tool data panel which is also weird, but the value occupies the same space.

Attached photos
 

Attachments

  • 20180922_104205.jpg
    20180922_104205.jpg
    83.4 KB · Views: 308
  • 20180922_104154.jpg
    20180922_104154.jpg
    100.4 KB · Views: 252
My 560v Has Wear. June of 2016 "Tool Wear Compensation" was listed on the quote as a no price option. I asked for itemized an it shows as $1900
 
There is a wear page, you're looking in the wrong spot.
I'm not at a machine right now, but it's one of the tool tabs. Might have to arrow right --->
 
There is a wear page, you're looking in the wrong spot.
I'm not at a machine right now, but it's one of the tool tabs. Might have to arrow right --->

On My 560 OSP300 The wear is on the Magazine info and Tool Data pages as shown in the image above.
 
Sorry this was long overdue.

$2200 option.

On a 180k deal.

Blows my mind the little 12x24 Sharp with the cheapest Fanic oi-mate has a proper tool table and its an OPTION on this machine.

Equally bizarre its not in any of the Okuma literature.

Dealer had it installed for us at no cost.

Machine was delivered a week before IMTS last year and it wasn't until 2 weeks after it was up and running, so they (and Okuma) owed us one.

All worked out in the end. Didn't even think to ask for something i would of assumed was so basic/universal.
 








 
Back
Top