dartplayer1
Plastic
- Joined
- Feb 28, 2005
- Location
- Marshall, Missouri
We just purchased two Okuma LB 3000 EX II lathes one has the new OSP-P300 L control.
With no warning and just cause the machine crashed and crashed hard.
We made 6 good parts then the crash.
In our shop we do not have a set-up person the operators are well trained they do all their own set-ups the guy
running this machine was setting up another lathe at the time of the crash so he did not see what happened.
We have analyzed the program and went thru everything on our end.
Our local dealer has been thru this thing and is working on rebuilding it, this new control even has a log file of everything the machine does Okuma did not
find anything we did to cause this problem.
However we still cannot get an explanation as to what caused the crash.
Okuma is standing by the machine warranty so we assume they have a problem but have yet to tell us what.
Anybody else seeing any problems with the OSP-P300L?
With no warning and just cause the machine crashed and crashed hard.
We made 6 good parts then the crash.
In our shop we do not have a set-up person the operators are well trained they do all their own set-ups the guy
running this machine was setting up another lathe at the time of the crash so he did not see what happened.
We have analyzed the program and went thru everything on our end.
Our local dealer has been thru this thing and is working on rebuilding it, this new control even has a log file of everything the machine does Okuma did not
find anything we did to cause this problem.
However we still cannot get an explanation as to what caused the crash.
Okuma is standing by the machine warranty so we assume they have a problem but have yet to tell us what.
Anybody else seeing any problems with the OSP-P300L?