Hello,
I was wondering if there is any workaround for the X values being off centerline as opposed to diametric when Y-Axis mode is turned on? Our CAM software currently doesn't take this into consideration so whenever I need to mill something in Y my X value is always double what it should be. Is there a parameter you can change so that the X values are unaffected by Y-Axis mode or is my only solution to get our post adjusted? This is on an OSP-P300L control.
Thanks.
I was wondering if there is any workaround for the X values being off centerline as opposed to diametric when Y-Axis mode is turned on? Our CAM software currently doesn't take this into consideration so whenever I need to mill something in Y my X value is always double what it should be. Is there a parameter you can change so that the X values are unaffected by Y-Axis mode or is my only solution to get our post adjusted? This is on an OSP-P300L control.
Thanks.
