I have a osp200m the atc is hung up on operation 25 and the spindle lost orientation,I am unable to step it forward or reverse because of orientation loss any ? Ideas
The entire tool change sequence is comprised of about 60-ish moves, his appears to be stuck on #25.
OP, I believe you have to go into system check mode, this will allow you to use the pulse handle to cycle slowly through the tool change sequence.
The only information I have on that is for the E100M control and it's an MC User Parameter that you have to change that allows the System Check Mode to be changed.
I could give you that info but it would more than likely be useless since it's for a much older machine and a different model.
This website or its third-party tools process personal data (e.g. browsing data or IP addresses) and use cookies or other identifiers, which are necessary for its functioning and required to achieve the purposes illustrated in the cookie policy. To learn more, please refer to the cookie policy. In case of sale of your personal information, you may opt out by sending us an email via our Contact Us page. To find out more about the categories of personal information collected and the purposes for which such information will be used, please refer to our privacy policy. You accept the use of cookies or other identifiers by closing or dismissing this notice, by scrolling this page, by clicking a link or button or by continuing to browse otherwise.