What's new
What's new

Osp200M

Barfiej

Plastic
Joined
Dec 15, 2020
I have a osp200m the atc is hung up on operation 25 and the spindle lost orientation,I am unable to step it forward or reverse because of orientation loss any ? Ideas
 
WTF is in op25?

The entire tool change sequence is comprised of about 60-ish moves, his appears to be stuck on #25.


OP, I believe you have to go into system check mode, this will allow you to use the pulse handle to cycle slowly through the tool change sequence.
The only information I have on that is for the E100M control and it's an MC User Parameter that you have to change that allows the System Check Mode to be changed.
I could give you that info but it would more than likely be useless since it's for a much older machine and a different model.
 








 
Back
Top