OSP700 vs OSP5000-L vs OSPE100L

rainman · Sep 7, 2016

Can anyone tell me if the programming is the same for these controls? I have to write a post for an Okuma Crown with OSP700. In the past I've run LB-15s with OSP5000, and have a manual for an OSPE100L. Thanks in advance.

Mtndew · Sep 20, 2016

It's been a LONG time since I programmed a 5000 control, but the basic language should be darn near identical.
There may be some features that the older controls might not have so I wouldn't get too fancy.

TimD · Jan 10, 2017

I'be been looking at used Okuma lathes for a project I have coming up. I had same question regarding the control versions. I'm looking at late 90's to early 2000 machines. These are the four different controls I keep running across.

E100L
U100L
U10L
7000L

The E100L and 7000L seem to be the most prevalent.
What's the difference between E100L and U100L?
What's the difference between U100L and U10L?

I'm guessing they are subsets of each other but what changes from one to the next. Any Okuma experts out there?

deadlykitten · Jan 10, 2017

TimD;2896648 said:
for a project I have coming up

what project ?

TimD · Jan 10, 2017

deadlykitten said:
what project ?

I'm not telling

Honestly though, I have a confidentiality agreement. Suffice to say that its large enough to buy a couple of used machines but not enough to warrant new.

deadlykitten · Jan 11, 2017

good luck !

Search

Largest Manufacturing Technology Community on the Web

Search

OSP700 vs OSP5000-L vs OSPE100L

rainman

Cast Iron

Mtndew

Diamond

TimD

Hot Rolled

deadlykitten

Banned

TimD

Hot Rolled

deadlykitten

Banned

Similar threads