ApexMachining
Plastic
- Joined
- Oct 23, 2017
Hi Guys,
Having an issue with a new to me LU15 lathe.
When I received the machine, the travel limit parameters were set to a tiny work envelope (approx. 100mm Z, 60mm X, on both turrets).
In the process of adjusting the parameters to allow full machine travel, I jogged the machine past the Z- end limit stop.
Now I have the problem of not being able to enter a new parameter because I have moved the turret past the limit.
It won't me use the limit release switch because the parameters are set wrong, not allowing the turret to be jogged Z+ direction.
Any suggestions on how to rectify this issue would be greatly appreciated.
Having an issue with a new to me LU15 lathe.
When I received the machine, the travel limit parameters were set to a tiny work envelope (approx. 100mm Z, 60mm X, on both turrets).
In the process of adjusting the parameters to allow full machine travel, I jogged the machine past the Z- end limit stop.
Now I have the problem of not being able to enter a new parameter because I have moved the turret past the limit.
It won't me use the limit release switch because the parameters are set wrong, not allowing the turret to be jogged Z+ direction.
Any suggestions on how to rectify this issue would be greatly appreciated.