Hi,
In my 840D I'm commissioning a 2-axis machine and I'm not able to get OFF1.
Everything seems correct, I tinkered a lot!
The only stuff I have some doubt about is the red cross on "Sync with NC" of slave no.3 in BUS TCP/IP.
When I make the CNC ready I can hear the main contactor closing but, after this I miss the OFF1 enable.
What can I do?
In my 840D I'm commissioning a 2-axis machine and I'm not able to get OFF1.
Everything seems correct, I tinkered a lot!
The only stuff I have some doubt about is the red cross on "Sync with NC" of slave no.3 in BUS TCP/IP.
When I make the CNC ready I can hear the main contactor closing but, after this I miss the OFF1 enable.
What can I do?