So I posted the general idea that we had a little while back in the general tab... Before I saw there was a robot section lol. So we have a cobot currently that feeds a vertical mill via a 'matrix'. Basically I stack parts on a table with a coordinate system that you teach the robot. Yes this lets the robot run for 18+ hours but we handle the parts way too many times between the saw, stacking, deburring etc. I acquired a pneumatic conveyor that I hooked up to an actuator and photoelectric sensor that delivers the part to the robot perfectly every time. NOW, I need to figure out how to get the saw integrated. What we need is a saw that can auto feed multiple bars without inputting length of stock etc as well as cutting ONE piece at a time when signaled, then dropping onto conveyor. That seems to be the hardest part. Tiger stop visited us and explained that we would need to override their software with our own plc to make this happen... Is this the only option or does anyone know of a saw that can feed once signaled like this? Hope this was clear and if not I can answer questions. Thanks in advance!