Hi,
I've Syntec cnc controller and I need to connect my pc to Syntec in order to get some machine info.
I've done it on Fanuc via RS-232 port with DPRNT commands. But when I run POPEN - DPRNT[xx] - PCLOS commands on Syntec it gives syntex error and stops processing. Does Syntec supports these commands?
And also is it possible to connect Syntec via ethernet port and just get machine status info?
Thanks,
Semih.
I've Syntec cnc controller and I need to connect my pc to Syntec in order to get some machine info.
I've done it on Fanuc via RS-232 port with DPRNT commands. But when I run POPEN - DPRNT[xx] - PCLOS commands on Syntec it gives syntex error and stops processing. Does Syntec supports these commands?
And also is it possible to connect Syntec via ethernet port and just get machine status info?
Thanks,
Semih.