Graziano SAG 12S filter and filter housing

noamw · Apr 5, 2020

Hi,

Anyone knows how to remove and inspect the oil filter?

From the drawings it seems that nothing is holding but the 3 x M6 screws that hold the clear window.

I removed the window and small impeller but I could not see how to get to the filter.

I triad to gently pull the aluminum impeller housing but it does not move. I do not want to break
anything.

Anyone out there knows how to do that ?

Thanks,
Noam.

Peter from Holland · Apr 9, 2020

I had a look and had it out in under 5minutes
Rotate the flange by inserting some pointy pliers and then pull at the same time
On the left of the second picture you can just see what tool I used

Dimensions of the filter are Ø=52.2mm L=71.5mm That is without the rubber gaskets
It is a brass filter so I just clean it and call it good
Important is that at assembling you keep the flange orientated correctly
(The big opening in the impellorhousing at the bottem )

Peter

noamw · Apr 9, 2020

Dear Peter,

Wow, thank you so much for the complete answer. I thought about it but I
was not sure and did not want to break anything.

Again thank you very much.

Take care,
Noam.

Peter from Holland · Apr 9, 2020

Biggest issue was to get the impellor back in
It bears in the plexiglass and to get that alligned verticaly is impossible
So I took out the housing again and installed the impellor and plexiglass horizontaly
Then installed the assembly in the machine

Peter

Search

Largest Manufacturing Technology Community on the Web

Search

Graziano SAG 12S filter and filter housing

noamw

Aluminum

Peter from Holland

Diamond

noamw

Aluminum

Peter from Holland

Diamond

Similar threads