I followed the instructions laid out in the manual and by the following thread:
https://www.practicalmachinist.com/...atador-headstock-assembly-help-please-289495/
I can't seem to get my alignment any better than .008". I loosened the nut at the front of the spindle and tightened the bearing, all according to the manual. I checked the alignment before I tightened the nut and it was off by maybe .001" which would have been totally acceptable, but when I tightened the nut, it again went back to .008". Does anyone have any suggestions?
Thanks
https://www.practicalmachinist.com/...atador-headstock-assembly-help-please-289495/
I can't seem to get my alignment any better than .008". I loosened the nut at the front of the spindle and tightened the bearing, all according to the manual. I checked the alignment before I tightened the nut and it was off by maybe .001" which would have been totally acceptable, but when I tightened the nut, it again went back to .008". Does anyone have any suggestions?
Thanks