Search Results - Practical Machinist - Largest Manufacturing Technology Forum on the Web
Close
Login to Your Account

Search:

Type: Posts; User: True.Scotsman

Search: Search took 0.00 seconds.

  1. I found the parameter. For this...

    I found the parameter.

    For this machine/control it’s in...

    - Machine Parameters
    - Table Sensor
    - L44 (0:Valid 1:Invalid)

    Selection of automatic setting on/off for nose position...
  2. Automatic Drill Length Compensation - MAZATROL 640M

    Machine: MAZAK MAZATECH FH-6800
    Control: MAZATROL 640M

    Does anyone know the parameters to control the automatic drill length compensation?

    I’m guessing there would be 1 parameter to switch the...
  3. Replies
    0
    Views
    2,916

    PLC parameters

    I have looked in all the manuals we have for our Integrex 300Y MKII 640MT. I can't find any PLC parameters. Are we missing a manual? Does anyone have a PDF version? The machine is set up totally...
  4. Replies
    6
    Views
    2,866

    We got it working. The machine thought the steady...

    We got it working. The machine thought the steady was unclamped (after restoring from back-up). It looks like an afterthought switch so maybe that's why. We connected the stready hydraulics unclamped...
  5. Replies
    6
    Views
    2,866

    Thanks for the replies. It must be a mark II...

    Thanks for the replies. It must be a mark II then. I will try checking B is square to Z axis at B0 before I go any further.

    We have a bigger problem now. The motherboard battery died. We are in...
  6. Replies
    6
    Views
    2,866

    Integrex 300Y Head Alignment

    The machine is an Integrex 300Y 640MT from 2000, not sure what mark (would be handy to know), 1 head, spindle and tailstock set-up.

    Sorry for the long post. Wanted to paint a full picture of the...
  7. Replies
    0
    Views
    984

    Circular Mill Tapered Hole

    Hi Guys,
    I am trying to machine a tapered blind hole using a Mazak Integrex e-650H-SII running on Mazatrol Matrix controller. The minor dia of the hole is 0.8" at 15deg taper either side x 1.685"...
  8. Replies
    18
    Views
    10,614

    I know this is an old one but did you re write...

    I know this is an old one but did you re write that program? Would it work on a Mazak?

    I am trying to machine a tapered blind hole using a Mazak Integrex e-650H-SII running on Mazatrol Matrix...
Results 1 to 8 of 8