Search Results - Practical Machinist - Largest Manufacturing Technology Forum on the Web
Close
Login to Your Account

Search:

Type: Posts; User: hotrod1442

Search: Search took 0.00 seconds.

  1. Gildemeister CTX 410 Operator Door Interlock Issue

    We are having troubles with our Gildemeister CTX 410's operator door interlock. It has occasionally had issues with the door not being able to open using the "unlock" button on the operator control...
  2. Replies
    1
    Views
    669

    HRT-210B Rotary Table Issue

    We have a 2004 VF5 with a HRT-210B rotary table, and are currently experiencing an alarm indicating an overload condition with the HRT-210B.Load meter is reading a 200% load when trying to rotate the...
  3. Gildemeister CTX 410 Chip Conveyor Won't Go Forward

    Our Gildemeister CTX 410 chip conveyor has stopped working, it is giving an alarm,(2159)"chip conveyor monitor triggered". The conveyor will go in reverse when the reverse jog button is held down,...
  4. DMG Gildemeister CTX 410, Error Message 2159 "conveyor monitor tripped" Help Needed

    Our Gildemeister DMG ctx 410 lathe is giving an error message 2159 "conveyor monitor tripped". Anyone have any input on what we need to do to correct this error, where is the conveyor monitor...
  5. DMG Gildemeister CTX 410, Error Message 2159 "conveyor monitor tripped" Help Needed

    Our Gildemeister DMG ctx 410 lathe is giving an error message 2159 "conveyor monitor tripped". Anyone have any input on what we need to do to correct this error, where is the conveyor monitor...
  6. VF5 Tool Release Issue After Using Thru Spindle Coolant

    We are experiencing an issue with the tool release after using the thru spindle coolant. The draw bar isn't extending enough to allow the tool to be released (and obviously not making the "release"...
  7. Who Repairs Plasma/Flame Cutting Table Controls SW Ontario Canada

    We have a Linatrol/Westcan Plasma/Flame cutting table, with the Lynx 84 control unit, that needs repairs to the longitudal drives. Not having any luck getting a technician from Linatrol out to repair...
  8. Replies
    2
    Views
    1,835

    Can't tell you the exact pressure (don't have a...

    Can't tell you the exact pressure (don't have a gauge installed), but I set the pressure by backing off the regulator until there was no pressure, and kept increasing slowly until I saw the precharge...
  9. Replies
    2
    Views
    1,835

    TRP problem on 2004 VF-5

    We are having an issue with our 2004 VF-5, the trp stutters while retracting/clamping a tool, causing it to alarm out.

    I checked for a broken return spring on the trp, but it looks fine. I then...
  10. We have the indicator mounted to the chuck,...

    We have the indicator mounted to the chuck, rotating the indicator around the live center.
  11. Mazak QTN Nexus 450M II Tailstock Alignment?

    We are trying to align the tailstock on our Mazak Lathe (Nexus 450MII) How is it done? After looking at the mechanical parts manual, we tried to adjust the center location by loosening the screws...
  12. Replies
    1
    Views
    1,722

    Turret Alignment Yang ML60A?

    We had a pretty bad crash on a Yang ML60A lathe. I was able to align the axis of the turret parallel with the axis of the spindle, but I can't seem to figure out how to adjust the tool position of...
Results 1 to 12 of 12