Search Results - Practical Machinist - Largest Manufacturing Technology Forum on the Web
Close
Login to Your Account

Search:

Type: Posts; User: Big B

Search: Search took 0.01 seconds.

  1. Replies
    52
    Views
    12,452

    Yes there is. An adapter that goes in your...

    Yes there is. An adapter that goes in your cordless drill for raising and lowering the knee is much preferred to my Kurt power drawbar.
  2. Replies
    52
    Views
    12,452

    That's the same one that I had with my last mill....

    That's the same one that I had with my last mill. I gave it to the guy that bought the mill because my B'port has a power drawbar.
  3. Replies
    52
    Views
    12,452

    I have a Kurt power drawbar on my Bridgeport and...

    I have a Kurt power drawbar on my Bridgeport and it is handy but I think a much bigger time and effort saver is the attachment that I bought that goes in a drill to raise the knee. Cost about 30...
  4. Replies
    52
    Views
    12,452

    I was trained as an apprentice to use the same...

    I was trained as an apprentice to use the same wrench to tap the top of the drawbar that I used to loosen the drawbar. Loosen it up a little bit, use fingers to unscrew it a turn or two and then rap...
Results 1 to 4 of 4