Search Results - Practical Machinist - Largest Manufacturing Technology Forum on the Web
Close
Login to Your Account

Search:

Type: Posts; User: michiganbuck

Search: Search took 0.04 seconds.

  1. Replies
    35
    Views
    6,560

    Original nut stub was 1.500" inch so perhaps a 1...

    Original nut stub was 1.500" inch so perhaps a 1 9/16 reamer might make a good bore.Measure to know the actual wash-out taper... I know .03 on a side is a lot but that is older cast iron..

    Here a...
  2. Replies
    35
    Views
    6,560

    my edit doesn't work on this new computer. My...

    my edit doesn't work on this new computer.
    My last post should have said OD work is often less than 6" long...not much/much..

    I do have a new Cinci#2 cross feed screw and nut I likely will never...
  3. Replies
    35
    Views
    6,560

    Agree a heavy and very good machine...one...

    Agree a heavy and very good machine...one drawback is not having a fine in-feed in tenths...but it doesn't take long to to go to the +.001 and then bump the hand wheel counting sparks..we ran .0001...
  4. Replies
    35
    Views
    6,560

    Cinci #2

    Most/much end sharpening is a grind slash only a short distance long..perhaps 1/8 to 1 inch..OD work is much/much less than 6" long. Check the error at mid table to see how straight that might be...
Results 1 to 4 of 4