Search Results - Practical Machinist - Largest Manufacturing Technology Forum on the Web
Close
Login to Your Account

Search:

Type: Posts; User: JasonPAtkins

Search: Search took 0.00 seconds.

  1. Replies
    16
    Views
    2,311

    Thanks everyone, I have my initial design, and my...

    Thanks everyone, I have my initial design, and my gears all ordered.

    I'll pick this thread back up in six months or so when the shipping container gets over to Africa and I start the build!
  2. Replies
    16
    Views
    2,311

    Thanks a lot, Gordon! Good to have more data...

    Thanks a lot, Gordon! Good to have more data points. I'm going to follow (as much as I can) the Eagle CP60 dimensions, which have a 60mm (little over 2-1/4") shaft dia where the rolls mount. Their...
  3. Replies
    16
    Views
    2,311

    Thanks a lot for the help. Now that I have some...

    Thanks a lot for the help. Now that I have some hard data about diameters and rolling speeds, I'm much closer. Ries, that diagram was super helpful - most of all in showing that my previous idea...
  4. Replies
    16
    Views
    2,311

    269898 Looks like you need a total of 1:240...

    269898

    Looks like you need a total of 1:240 gearing from a 1440 rpm motor (50hz) to the final rolling shaft output. In my case, with a 23:1 gear reducer on the motor, I need a further 10:1...
  5. Replies
    16
    Views
    2,311

    For posterity, I had looked at Eagle's site,...

    For posterity, I had looked at Eagle's site, which didn't answer these questions, but their manual at https://www.eaglebendingmachines.com/eaglepdfs/CP40.pdf does. I'm glad to use their shaft...
  6. Replies
    16
    Views
    2,311

    Beautiful, Ries - thanks! Could I ask for...

    Beautiful, Ries - thanks!

    Could I ask for three measurements to get me going?

    1) Diameter of the shafts the tooling slides onto (tooling bore)
    2) Distance between the centers of the two lower...
  7. Replies
    16
    Views
    2,311

    This is a really old thread, but I now have a...

    This is a really old thread, but I now have a shipping container headed over to West Africa and want to make sure I'm sending what I need to get this build done. I now have a 3hp Baldor on a gear...
  8. Replies
    16
    Views
    2,311

    Thanks for the feedback. Old thread, but I now...

    Thanks for the feedback. Old thread, but I now have a carrier to bring over the precious bronze I need for the bearings for this. I ended up watching amazon and scooping up "last one in stock"...
  9. Replies
    16
    Views
    2,311

    Thanks for the feedback. I have heavier duty...

    Thanks for the feedback. I have heavier duty motors here, but none with that nice 60:1 gearbox on them. I'll probably use this and have the sprockets just run it slow to get enough torque until the...
  10. Replies
    16
    Views
    2,311

    Thanks Doug. Dimple or file test to see if it's...

    Thanks Doug. Dimple or file test to see if it's pre hard, or what's my best way to get a good idea?
  11. Replies
    16
    Views
    2,311

    Supplies for stout ring roller build

    Hi all, I've been away for a while, but get to get back to work soon!

    I work at a fab school in West Africa and get to send a limited amount of stuff in a shipping container headed out soon. One...
Results 1 to 11 of 12