Search Results - Practical Machinist - Largest Manufacturing Technology Forum on the Web
Close
Login to Your Account

Search:

Type: Posts; User: JCA

Search: Search took 0.00 seconds.

  1. Replies
    0
    Views
    630

    Help with DoAll D6 Surface Grinder

    I have lost the top cover for the vertical post of my DoAll D6 Surface grinder. I am looking for perhaps someone who is scrapping out alike machine. Short of that, I am looking for a machine that I...
  2. Replies
    4
    Views
    1,185

    Recommended leveling pads for BP Series One

    :)Happy New Year to all. Looking to install leveling pads on my Series 1 Bridgeport. What brand and weight capacity of pads are recommended for this machine.
  3. One additional picture

    One additional picture of shaft # 109 in the feed gear box
  4. #2 H KT Horizontal Pictures

    Attached are a few pictures from the machine. One is missing
  5. Hi I an in Tacoma. I do need help. My machine is...

    Hi I an in Tacoma. I do need help. My machine is located on South Adams Street Just off South Tacoma Way. I would appreciate any assistance you could offer. I can see the pictures I attempted to...
  6. Tom: I have prepared a couple snips out of the...

    Tom: I have prepared a couple snips out of the manual and photos that perhaps will better help explain my challenges. Perhaps this will help but I am not sure I have attached the files.
  7. Thank you. I will try and clean up the question....

    Thank you. I will try and clean up the question. I have a manual. The knee or feed gear box is not removed. The speed gear box is not removed. I will follow your instructions . Pictures to follow...
  8. Thread: Boeing EE

    by JCA
    Replies
    351
    Views
    67,644

    How is your machine progressing. I have one in...

    How is your machine progressing. I have one in Tacoma. Did Lindmark do a good job on the grinding. Who did you use to scrape the machine in? Jim
  9. Assembly help with #2 H Kearney Trecker Horzionatal

    About ten years back I started to disassemble my #2 KT. Timme paasees by. I now want to reassemble the machine. My problems that I know about at this point!!! I took off the speed change dial. How...
Results 1 to 9 of 9