Search Results - Practical Machinist - Largest Manufacturing Technology Forum on the Web
Close
Login to Your Account

Search:

Type: Posts; User: mjk

Search: Search took 0.01 seconds.

  1. Thread: Cazeneuve HB575

    by mjk
    Replies
    25
    Views
    6,400

    Found this on Youtube, not mine and its a 500,...

    Found this on Youtube, not mine and its a 500, but same setup
    notice the thread dial on the left side

    YouTube

    At 2:06 the operator is engaging the threading lever
  2. Thread: Cazeneuve HB575

    by mjk
    Replies
    25
    Views
    6,400

    That 4" dial is not for threading, Your...

    That 4" dial is not for threading,
    Your threading dial is missing, it is mounted on the left side as my pic shows.
    I'll take a few more closeups when back at the shop

    I'll see if I can take a...
  3. Thread: Cazeneuve HB575

    by mjk
    Replies
    25
    Views
    6,400

    On your machine pulling up on the red round knob...

    On your machine pulling up on the red round knob on the left side of the carriage engages the half nut for threading

    The dial that is approx 5" in diam, right center of the carriage is indicating...
  4. Thread: Cazeneuve HB575

    by mjk
    Replies
    25
    Views
    6,400

    Hers a pic of the thread dial on mine, don't see...

    Hers a pic of the thread dial on mine, don't see the one on yours evan after flipping your pic
  5. Thread: Cazeneuve HB575

    by mjk
    Replies
    25
    Views
    6,400

    How about posting a pic of the thread dial

    How about posting a pic of the thread dial
  6. Thread: Cazeneuve HB575

    by mjk
    Replies
    25
    Views
    6,400

    2nd the starting a new thread. I haven't done...

    2nd the starting a new thread.

    I haven't done a lot of manual thread cutting in my life compared to many on PM, but I will say I was able to figure out and produce acceptable threads for parts...
Results 1 to 6 of 7