Search Results - Practical Machinist - Largest Manufacturing Technology Forum on the Web
Close
Login to Your Account

Search:

Type: Posts; User: EmanuelGoldstein

Search: Search took 0.01 seconds.

  1. I can assist with this part ... 283329

    I can assist with this part ...

    283329
  2. Can be off .0001 or .0002 without noticing a...

    Can be off .0001 or .0002 without noticing a difference. I've done even more if it was unavoidable but don't like to. On a helical I always tried to wind them up tighter because they unwind in heat...
  3. An error of one or two in the fourth place is...

    An error of one or two in the fourth place is fine. You can even stretch that, but it's a good goal. And they don't frown on it, it's in the manuals. There's more manufacturers than just...
  4. Like me learning to become a card shark ? Umm,...

    Like me learning to become a card shark ? Umm, yeah :D


    Might be easier .... but it can be done, the underlying problem is vibration and the arbor is so small, there's no rigidity. A tiny little...
  5. David, have you ever actually done this ? It's a...

    David, have you ever actually done this ? It's a little different reading about it in a book, you know.

    Normally, cutting forces are directed into the table and they are generally along the axis...
  6. 'scuse me ? If you have setup sheets and they...

    'scuse me ? If you have setup sheets and they were doing this for years, is there some reason you don't just do what was working ?

    Inquiring minds and all that ...
  7. Basically, yes. OP, you are going to break lots...

    Basically, yes. OP, you are going to break lots of hobs and cry a lot. I did a bunch of 67* left-handers and hated every second of it. There is no good answer. If you told Barber-Colman what you were...
Results 1 to 7 of 7