Search Results - Practical Machinist - Largest Manufacturing Technology Forum on the Web
Close
Login to Your Account

Search:

Type: Posts; User: Swarthy

Search: Search took 0.00 seconds.

  1. Replies
    17
    Views
    1,444

    Marked lines under the steady and dragged it on...

    Marked lines under the steady and dragged it on fine sand paper clamped to the bed, lifting up a bit on the flat side so the v side is true to the bed.

    I tried to scrape with file then an old...
  2. Replies
    17
    Views
    1,444

    Thanks I think that's the best solution, As I...

    Thanks I think that's the best solution, As I machine allot of chrome rods and I need the rollers to be in line as to not make a marks on the rods.
  3. Replies
    17
    Views
    1,444

    This is a roller bearing type steady rest. I have...

    This is a roller bearing type steady rest. I have to put a bit of gasket .020" under the one side. I marked a cross pattern and found the hi/low spots.

    My Question to all is how to make a jig or...
  4. Replies
    17
    Views
    1,444

    New to me !

    New to me !
  5. Replies
    17
    Views
    1,444

    It's new first use noticed wobble, made in SHItNA...

    It's new first use noticed wobble, made in SHItNA I think it's not made machined right. I marked pattern on it with magic marker so i could see the contact points. At top adjusting screw it has a...
  6. Replies
    17
    Views
    1,444

    Steady Rest wobble

    My steady rest has a bit of a wobble, when just sitting on the bed. I want to try to true the bottom up. any suggestions. I tried some sand paper under the steady and dragged it on the bed and I...
Results 1 to 6 of 6